788c Software Update and Transducer

1100, 900, 800 and 700 series Units without Side Imaging
Post Reply
wmreid
Posts: 2
Joined: Mon May 24, 2010 3:04 pm

788c Software Update and Transducer

Post by wmreid » Mon May 24, 2010 3:26 pm

I recently bought a new fishing boat with a 788c installed in the bow. The transducer is within the trolling motor. I updated the software per Humminbird instructions to the most recent version (4.780) this past weekend. I reset the unit, installed the upgrade, and then reset again. I cannot get downscan. Does the transducer have to be a sidescan capable transducer for this feature to be enabled? Thank You
WMR

sonartech
Posts: 20
Joined: Mon May 24, 2010 3:59 pm
Location: Canada

Downimaging on a 788c

Post by sonartech » Mon May 24, 2010 4:08 pm

Hi wmreid: Yes the unit must be side scan capable to display downimaging. Your 788 is not a sidescanning unit, but it does utilize dual beams (200 and/or 83 kHz) and is a very decent upper end model. Unfortunately you would have to move up to the similar 798CSi to get the side scanning capabilities.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest

Created by Matti from StylesFactory.pl and Warlords of Draenor
Powered by phpBB® Forum Software © phpBB Limited
 

 

cron